STARR GUITAR SYSTEMS entry level wiring harness for Fender P-Bass
The basic model is our low cost system solution if you just want to get an old bass up & running, or building a bass and want to save some money!
Included in each PB-Basic set:
2) 250K Alpha Pots, Audio Taper, with hardware
1) Yibuy .047 mfd Capacitor
4) Gavitt 22 gauge guitar wire
1) Mojo Tone input jack with heat shrink protection covering both terminals.
1) Bridge ground wire
1) Wiring diagram (sent via email)
1) Assembly template board
Each set is assembled, hand wired and soldered in the USA using premium parts. Upgrade your import bass electronics, or replace your old worn out parts with these brand new low priced replacement units! Simply attach your pickup wires, bridge ground wire and you are ready to rock! All sets are signed by Dave Starr and have their own serial number.
Note: Most guitars manufactured overseas in South Korea, Japan, China, Indonesia and Mexico use 6mm metric pots and have metric sized holes drilled. You will need to enlarge the pot holes slightly to 3/8" to fit these pots properly.