STARR GUITAR SYSTEMS Fender P-Bass Harness for ACTIVE pickups (EMG)
Love your active pickups, but prefer the old school way of wiring them before the industry went to the all solder-less systems??
Included in each SGS P-Bass "ACTIVE" (EMG) set:
2) Alpha 25K audio taper short shaft split pots, with nut, lock and dress washer.
1) 0.1 mf Capacitor
4) Gavitt 22 gauge guitar wires
1) USA made Switchcraft stereo input jack with heat shrink strain relief on all 3 terminals.
1) 9 volt battery clip
1) Wiring diagram (see photo section)
1) Assembly template board
Premium replacement electronics for your active EMG powered Fender P-Bass! Each set is assembled, hand wired and soldered in the USA using premium parts. Upgrade your import bass electronics, or replace your old worn out parts with these premium replacement units! Simply attach your pickup wires, bridge ground wire, and you are ready to rock! All sets are signed by Dave Starr and have their own serial number.
Note: Most guitars manufactured overseas in South Korea, Japan, China, Indonesia and Mexico use 6mm metric pots and have metric sized holes drilled. You will need to enlarge the pot holes to 3/8" to fit these CTS pots properly.