Wiring Harness for Epiphone Embassy Pro Bass: Standard

Regular price $71.40

STARR GUITAR SYSTEMS harness upgrade for Epiphone Embassy Pro Bass - Standard version.
Let those ProBucker Bass # 760 Humbucker pickups really ring out!

Included in each SGS Epiphone Embassy Pro Bass System:

1) CTS 500K Audio Pot for master volume, split shaft, with Nut, Lock and Dress Washer.
1) Bourns 500K Blend/Balance Linear Taper Pot, split shaft, Center Detent, with hardware.
1) CTS 500K Audio Pot for master tone, split shaft, with Nut, Lock and Dress Washer.
1) "Orange Drop" .047 mfd 100 volt Capacitor
4) Vintage style push back black (ground) and white (hot) cloth covered wires, 22 gauge, with a waxed braided cotton outer insulation.
1) Switchcraft #151 mono input jack with heat shrink strain relief on both terminals
1) Wiring diagram (see photo section)
1) Assembly template board

Each set is assembled, hand wired and soldered in the USA using premium parts. Upgrade your import bass electronics, or replace your old worn out parts with these premium replacement units! Simply attach your pickup wires, and bridge ground wire and you are ready to rock! All sets are signed by Dave Starr and have their own serial number. Free Shipping in the USA!

Note: Most guitars manufactured overseas in South Korea, Japan, China, Indonesia and Mexico use 6mm metric pots and have metric sized holes drilled. You will need to enlarge the pot holes to 3/8" to fit these CTS pots properly.