STARR GUITAR SYSTEMS harness upgrade for Fender Bullet Bass.
Included in each Bullet Bass system:
2) CTS 250K audio taper short split shaft pots, with nut, lock and dress washer. (includes 2 brass adapter sleeves if needed)
1) "Orange Drop" .047 mfd 100 volt Capacitor
4) Vintage style push back BLACK (ground) and WHITE (hot) cloth covered wires, 22 gauge, with a waxed braided cotton outer insulation.
1) Switchcraft #11 input jack with heat shrink strain relief on both terminals.
Included in each Bullet Bass system:
2) CTS 250K audio taper short split shaft pots, with nut, lock and dress washer. (includes 2 brass adapter sleeves if needed)
1) "Orange Drop" .047 mfd 100 volt Capacitor
4) Vintage style push back BLACK (ground) and WHITE (hot) cloth covered wires, 22 gauge, with a waxed braided cotton outer insulation.
1) Switchcraft #11 input jack with heat shrink strain relief on both terminals.
1) Wiring diagram (in photos above, same as P-Bass)
1) Assembly template board
Each set is assembled, hand wired and soldered in the USA using premium parts. Upgrade your import bass electronics, or replace your old worn out parts with these premium replacement units! Simply attach your pickup wires, and bridge ground wire and you are ready to rock! All sets are signed by Dave Starr and have their own serial number. Free Shipping in the USA!
Note: Most guitars manufactured overseas in South Korea, Japan, China, Indonesia and Mexico use 6mm metric pots and have metric sized holes drilled. You will need to enlarge the pot holes to 3/8" to fit these USA CTS pots properly.
